Dos and Don’ts – N3 Ready

✅ Do's – What you should do

1. Transport. Always move the N3 Ready by lifting it by the handle.
2. Clean regularly. Wipe down the robot regularly, especially around the LIDAR (the sensor on top) and the sensors on the sides, to prevent dust, dirt, and grit from accumulating there.
   
3. Avoid moisture. On particularly wet days, use a wet vacuum before use.
4. Be careful around heights. N3 Ready can withstand impacts with obstacles, but not falls down stairs or from heights.
   
5. Mapping function. While the robot is mapping, avoid positioning it directly facing windows with strong sunlight, as this may interfere with the mapping process.
6. Monitor for error messages. If an error message occurs, the cause must be identified and resolved before further use.
7. Maintenance. Remove any hair and threads caught in the ends of the brushes to prevent malfunctions.
8. Safety first. In areas where children and young people are present, consider removing the cutting blade from the robot.

❌ Don'ts – What you should not do

1. Do not place the robot upside down. The LiDAR cannot withstand the weight of the robot.
2. Do not use dirty or damaged parts. Use only approved, clean brushes, filters, and replacement parts.
3. Do not put damp filters or brushes back into the robot. This may damage the motor or electronics.
4. Do not expose the robot to water, snow, or extreme humidity. This may damage the electronics.

Contact customer service by phone at 02131 or kundeservice@n3.no for questions not answered in this manual.